Here are five easy steps to roll fenders in less than 30 minutes.
• Step One: Mark out the area of interference on the fender Step Two: Using a heat gun, heat the surface to about 120 to 140
degrees to soften the paint • Step Three: Start squeezing the fender lip and rolling upward a little at a time, keeping heat in the area and softness in the paint • Step Four: Squeeze and roll the fender lip upward, gradually removing the flange from 90 degrees up to 180 degrees • Step Five: Repeat this process five or six times, until the fender lip is flush with the outer fender * The Fender Finisher, the only hand-held pro-grade fender forming tool is approximately 12”L, and is constructed from a stamped steel frame with molded handgrips and a durable powder coated finish.(800) 343-9353 www.eastwood.com